§ Standards
Status
CURRENT
Last verified
2026-09-06
Bureau of Indian Standards · STANDARD
IS 4759
Hot-Dip Zinc Coatings on Structural Steel and Other Allied Products
Overview
What this standard covers
Coating mass requirements for galvanized structural steel in India.
Coating mass requirements for galvanized structural steel in India.
Who uses it
Designers, galvanizers and coating inspectors agreeing coating thickness, venting and appearance.
Details
Reference data
- Standard number
- IS 4759
- Title
- Hot-Dip Zinc Coatings on Structural Steel and Other Allied Products
- Organisation
- Bureau of Indian Standards
- Country
- India
- Region
- India
- Subject
- Galvanizing
- Subcategory
- Coating
- Type
- STANDARD
- Application
- Contractual
- Availability
- Paid
- Status
- CURRENT
- Roles
- coating standard
- Last verified
- 2026-09-06
Official source: services.bis.gov.in
Related
Standards used alongside this one
- IS 2629
Recommended Practice for Hot-Dip Galvanizing of Iron and Steel
Indian recommended practice for hot dip galvanizing, including preparation and handling.
IndiaGalvanizingCURRENTPaid
- BS EN ISO 1461
Hot dip galvanized coatings on fabricated iron and steel articles
Minimum mean coating thickness by article thickness, plus appearance, adhesion and repair requirements for hot dip galvanizing after fabrication.
United KingdomGalvanizingCURRENTPaid
- ASTM A123/A123M
Zinc (Hot-Dip Galvanized) Coatings on Iron and Steel Products
US coating thickness grades by material category and thickness — the ASTM counterpart to ISO 1461.
United StatesGalvanizingCURRENTPaid
- ASTM A153/A153M
Zinc Coating (Hot-Dip) on Iron and Steel Hardware
Galvanized coatings on bolts, nuts and small hardware, where centrifuging and thread clearance matter.
United StatesGalvanizingCURRENTPaid
- ASTM A385/A385M
Providing High-Quality Zinc Coatings (Hot-Dip)
Design and detailing practice for galvanizing, including venting, drainage and avoiding overlapping surfaces.
United StatesGalvanizingCURRENTPaid
- BS EN ISO 14713-2
Zinc coatings — Guidelines and recommendations for hot dip galvanizing
Design guidance for galvanizing: venting and draining holes, distortion control, joint detailing and expected coating life by environment.
United KingdomGalvanizingCURRENTPaid
Sourcing, review and use
Status
Editorial reference information compiled and maintained by the StructuralSteel.ai team. It is not a design certificate and is not issued under an engineer's seal.
Last reviewed
Calculations
Any figures produced on this page are indicative estimates for early sizing and comparison only — they are not engineered design outputs.
References
Final member selection, loading, connection design, fire design, fabrication and compliance must be verified for your specific project by a suitably qualified structural engineer. Standards are revised; check the edition in force where the work is built.
Verification
StructuralSteel.ai provides technical reference information and links to authoritative sources. Project specifications, applicable legislation, current standards editions and requirements of the responsible engineer or authority should always be verified before fabrication or supply.